Oxygen Clean Service

Oxygen cleaned pressure transducers & transmitters which have dry sensor cells or contain halocarbon oil fillings that can be used where Oxygen service is required such as pure gas generation and emergency life support equipment.

ATEX approved hydraulic pressure sensor for instrinsically safe use in hazardous areas with a 4-20mA current loop output signal in pressure ranges from 50 up to 1000 bar gauge

General purpose industrial pressure transmitter with a 4-20mA current loop or amplified voltage output available in range from -1 to +1 barg up to 500 barg

High pressure transducer for pressure testing applications with 4-20mA current loop or amplified voltage output signal available in pressure ranges from 50 up to 1000 bar gauge to with a measurement accuracy of 0.1%.

Piezo-resistive pressure sensor with a millivolt output direct from a four arm wheatstone bridge strain gauge circuit in pressure ranges from 10 up to 1000 bar gauge.

Highly accurate digitally compensated pressure transducer with G1/2 male flush pressure port. Designed for use on viscous media or where a flush face is required for easier cleaning when used with food, drink or hazardous substances such as Oxygen. Select pressure ranges as low as 1 bar or as high as 1000 bar. Standard digital output is RS485 which can be converted to RS232 or USB via optional converter cables.

Dual analogue output signal transmitter for simultaneous measurement of media pressure and temperature. Pressure ranges from 100 mbar up to 1000 bar and temperature measuring range from -25 to 100 DegC. To ensure good thermal contact with the media the temperature is measured just behind a flush diaphragm which has sufficient surface area to ensure minimal losses in media temperature at point of measurement.

Screw-in pressure transmitter with flush stainless steel 316L diaphragm for measuring pressures of fluids with very high viscosity from 15 psi up to 6000 psi gauge or absolute. Options available for high temperatures up to 300 deg C and intrinsic safety.

Passive compensated pressure transducer with a four arm semiconductor Wheatstone bridge circuit which produces a 100 millivolt with a 10 volt excitation. Pressure ranges from 0-100mbar up to 0-1000bar gauge or absolute. The silicon sensing chip is totally isolated from the media by an oil filled stainless steel 316L capsule with isolation membrane. This sensor is ideally suited for high frequency response applications since the output is only limited by the natural response of the silicon sensing capsule.

Rangeable Pressure Transmitter with an all stainless steel construction with LCD digital readout display and optional HART communications. Specifically designed for use in food, dairy, pharmaceutical or biotechnology applications where ultra clean crevice free flush diaphragms are required.