High output hydrostatic liquid level sensors with a 5 volt span scaled from zero to five volts.
Economical IP68 protected sensor with stainless steel 316L housing and Ceramic strain gauge sensing diaphragm for measuring liquid depth pressure or the pressure in a submerged pipe or vessel. Measure hydrostatic pressure from from 0 to 10 mWC (33 ftWC) up to 0 to 100 mWC (330 ftWc) and convert reading to a millivolt, current or voltage signal output. The Ceramic diaphragm has a high chemical resistance to media such as leachate and seawater, and the housing can be upgraded to Duplex stainless steel if necessary for extra material protection. A PUR coated cable is fitted as standard, but for additional chemical protection an FEP coated cable can be supplied.
Immersible low pressure sensor for measuring shallow liquid level with a rangeable 4-20mA current loop or high level voltage output signal in level ranges from 80mmH20 up to 160mH2O
Absolute referenced hydrostatic depth sensor with an IP68 sealed electrical interface, stainless steel 316L, Duplex or PVC housing and a mV, amplified voltage or current output. Available in depth ranges from 1 to 10 bar absolute.
Water resistant pressure sensor for measuring hydrostatic pressures in the range of 0-0.5 mWC up to 0-100 mWC. An all stainless steel 316L construction with Viton O rings seals and a choice of PUR, PVC or FEP vented cabling. The IMSL is used for measuring groundwater, aquifer, reservoir and borehole water level. The internal silicon strain gauge sensor provides a stable water level reading accurate to 0.1% of span linearity with low hysteresis and repeatability errors.
IP68 protect pressure sensor for monitoring fresh water level to depths of 100 metres. This stainless steel drinking water compatible level sensor has been assesed and certified by the Water Regulations Advisory Scheme (WRAS) for compliance with the UK water regulations. The materials and fittings used in the mechanical construction of the IWSL water level sensor meet the standards required by the water supply byelaws of England, Wales and Scotland.
Analogue output sensor for immersing in seawater to determine depth or change in water level by measuring hydrostatic pressure. This sea depth probe has a Marine bronze housing and Ceramic diaphragm for protection from saltwater corrosion. Select fixed ranges from 10 metres (33 feet) up to 100 metres (328 feet) depth in a number of analogue output configurations including low voltage strain gauge, amplified voltage and current loop output. Also suitable for use in brackish and inland tidal water or any other application where there is the risk of corrosion form a saline liquid.
tel: +44 (0)844 800 9440
©2013 SensorsONE Ltd, all rights reserved.